7.7 Operating Point Selection

• We are often interested in amplifying time-varying signals.
• Because the amplifier turns off for input voltages less than VT, it is important to add an appropriate DC offset voltage to the time-varying input signal so that the amplifier remains in the saturation region for the entire range of input voltage variation.
• This input DC offset voltage defines the operating point of the amplifier.
• The DC offset must be chosen carefully, for if it is too large, the amplifier will be pushed into the triode region, and if it is too low, the amplifier will slide into the cutoff region.
• The input offset voltage is also called the input bias voltage or the input operating voltage
• The corresponding output voltage and the output current define the output operating point of the amplifier.
• Valid range for operating point under the saturation discipline:

7.6 Large-Signal Analysis of MOSFET Amplifier

• Two forms of analysis come in handy for amplifiers: a large signal analysis and a small signal analysis
• Large signal analysis deals with how the amplifier behaves for large changes in input voltage. (changes that are of the same magnitude as the operating parameters of the amplifier)

7.5 MOSFET Amplifier

•  Transfer function of the amplifier:

• Biasing the MOSFET amplifier:

• Clipping effect on output signal (input signal with zero DC offset/bias:

• Vx and Vy of Figure 7.25 are operating points/ bias points

 

7.4 Switch-Current Source (SCS) MOSFET Model

• SCS Model:

• K parameter:

• Characteristic in saturation region:

7.3 Actual MOSFET Characteristics

• SR model of MOSFET is inadequate when VDS >= VGS - VT 
• MOSFET characteristics match the SR model for a fixed value of VGS, VGS >= VT and VDS is small (VDS < VGS - VT) :

• IDS begin to saturate when VDS approaches the value of VGS - VT

• Saturation region of MOSFET operation

• SR and SCS (switch current source) model:

7.2 Review of Dependent Sources

• Amplifiers are naturally modeled using dependent sources

• Dependent sources serve to model control of energy or information flow

CHP 7 MOSFET Amplifier: 7.1 Signal Amplification

• Signal amplification (analog):

• Depending on internal structure, an amplifier can amplify input current, voltage or both
• When V x I product of output exceeds input's, power gain results
• A device must provide power gain to be called an amplifier 
• Noise tolerance through amplification:

• Another amplifier application: buffering